Tax incl. Tax excl.
  • -15%
  • New
Scotch-Weld Photo Mount, adhesivo en aerosol para fotografías

3M Photo Mount, professional grade permanent adhesive

8 Items

By buying this product you can collect up to 1 point. Your cart will total 1 point that can be converted into a voucher of €0.10.

€15.26 Tax incl. €15.26 Tax excl.

Improved 3M PhotoMount is a professional grade adhesive which provides a permanent bond for mounting photographs,
maps, prints and drawings. It can be used on most porous and non porous materials.

 Calculate Shipping Cost
to España via
Estimated delivery: No estimated delivery specified day(s)
Ratings and comments from our customers
( 0.0 / 5) - 0 feedback(s)

Improved 3M PhotoMount is a professional grade adhesive which provides a permanent bond for mounting photographs,
maps, prints and drawings. It can be used on most porous and non porous materials. It is a clear adhesive and slow drying to allow a short time for pinpoint positioning before final bonding.The new controlled spray pattern greatly reduces adhesive mist.

Physical Properties (Not for specification purposes)

Solvent: Petroleum Distillates, Pentane, Acetone
Flash Point: -46°C (propellant)
Propellant: Propane, Hydrocarbon
Contents: 400 ml (260g)
Spray Pattern: Particle
Colour: Clear
Shelf Life: 12 months from date of production when stored in the original carton at 21°C (70°F) & 50 % Relative Humidity.

Storage Conditions

Cool dry place. Best results are obtained when material is stored and applied at room temperature 16 to 27°C.
Storage temperature must not exceed 49°C.

Directions for Use

Ensure all surfaces to be bonded are clean, dry and free from dust, oil and grease before application of adhesive.
Ensure that the nozzle points away from all persons and towards the surface to be sprayed.
Turn the spray tip to select the desired spray width.

Shake can well before using, 5-10 seconds should be sufficient. Hold the container 15 to 20 cms from the surface and apply evenly to cover the entire area.

To bond porous materials (such as paper, board and fabric) apply to one surface only and place in position while the adhesives is still wet. For non porous materials (such as metal foils, plastics and film) spray adhesive onto both surfaces and let adhesive become aggressively tacky before bonding.

To prevent nozzle from blocking, at the end of each day turn the can upside down and press the tip until spray is clear from adhesive, and wipe tip.

Clean Up: Spray nozzle or excess adhesive may be cleaned with white spirits.

NOTE: When using solvents for clean up, it is essential that proper safety precautions are observed.

8 Items

Customers who bought this product also bought:

Product added to wishlist