Tax incl. Tax excl.
Carbon Skin Adhesive

Carbon Skinning Adhesive

CRBADHESIVE-0.5
1 Items
Last items in stock
€82.00
€99.22 Tax incl. €82.00 Tax excl.
Tax excluded

By buying this product you can collect up to 9 point points. Your cart will total 9 points that can be converted into a voucher of €0.90.

Adhesive specially designed to cover pieces in carbon or other types of fabrics, on virtually any surface, plastics, metals, wood, etc. On PP it is necessary to sand the surface very well with large grain sandpaper.

Choose the type of supply



 Calculate Shipping Cost
Ratings and comments from our customers
( 0.0 / 5) - 0 feedback(s)

Adhesive specially designed to cover pieces in carbon or other types of fabrics, on virtually any surface, plastics, metals, wood, etc. On PP it is necessary to sand the surface very well with large grain sandpaper.

Technical specifications:

Viscosity: 190mPas

Processing temperature: 20-25 ° C

Processing method: Application with flow cup gun with 2mm nozzle at 1.5-2 bar.

Color: black (hardener and adhesive)

Mixing ratio: 100: 5-7 (by weight)

Consumption: 180g / m²

Tg: 135 ° C

Solids content: approx. 15%

Pot life:

Different, depending on the ambient conditions up to 8 hours

Special features: The already mixed adhesive can remain airtight for 1 week in the gun.

 

Processing instructions:

Mix the adhesive according to the mixing ratio given above.

Sand the part surface and clean thoroughly with a cleaning agent (acetone or silicone remover). From now on only work with nitrile gloves.

Apply adhesive by gun in 1-2 thin layers over the part and let it dry for 10 minutes. At the same time, sprinkle the fabric also with 2 coats (1 thin coat (5 min wait) + 1 full coat). Again, a ventilation time of 10min should be maintained.

The adhesive causes the dried fabric to be slip-strengthened and thus preserved. 

Place the dried fabric on the part and align it. Then heat it with a hot air blower and a temperature of 250-300 ° C and make pression on the part. After the whole part is covered, it is recommended to heat it completely with the hair dryer and press the fabric evenly.

Allow the component to harden for 5 hours at 35-40 ° C in the oven or for one day at room temperature. Subsequently, the adhesive is no longer reactivated, solvent-resistant and can only be removed mechanically by grinding component.

Then proceed with the resin of your choice (we suggest the Crestapol 126 when a high Tg is required and the RESOLTECH 1070).

Storage:

It is recommended to store both products in a cool place and away from the incidence of sunlight. It is advisable to store the hardener in a refrigerator to extend its shelf life.

Type of Supply

Carbon Skin Adhesive x 0.5l + hardener, supplied in plastic containers.

Carbon Skin Adhesive x 1l + hardener, supplied in plastic containers.

1 Items
8431252538935

Customers who bought this product also bought:

Product added to wishlist