Resolcoat 3010T/3014T Epoxy High Build Surfacer

RESOLCOAT 3010T is a high build surfacer formulated to create a barrier against water and chemicals to protect a yacht hull as well as providing a perfect surface finish and interface for all marine topcoats.

The system is easy to apply by spray, roller or brush and is fast drying. A suitable finish is obtained after at least two coats of this system. Suitable for steel, aluminium, GRP and wooden yachts.

Mixture ratio of 100: 15 by weight, or 4: 1 by volume.

Gel time: 16 h for 1 liter.

Use thinner 3018 for spray applications: approximately 10-15%.

SPRAYING: Pressure required: Airless:150kg/cm2. Use 0.46/0.69mm nozzles thinned with
RESOLTECH 3018 thinner at 10 to 15%. If sprayed without using thinner with a classic gravity
spray gun, use a nozzle of 2,6 mm with min 4-6 bar air pressure.
COVERAGE: 4m2 per kg. on average for a 100 microns dry layer (recommended amount/layer)
Several layers can be applied until a fair surface is obtained (usually 2 coats ). No sanding is required
between coats. Once cured, the filler can be sanded with an orbital sander.
“Pinholes” should be treated with a mixture of Resolcoat 3010T and HP510 glassbubbles. Do not
use another filler as it may create “hard points”. Avoid thick coats that may lead to solvent entrapment.
Tools should be cleaned with acetone, thinner or any equivalent product.

Type of supply

Resolcoat 3010T/3014T Epoxy High Build surfacer x (1+0.15) kg

Resolcoat 3010T/3014T Epoxy High Build surfacer x (4+0.6) kg

Resolcoat 3010T/3014T Epoxy High Build surfacer x (20+3) kg