Tax incl. Tax excl.
Crystic 15PA Vinyl Ester brush Tooling Gel Coat

Crystic 15PA High Performance Vinylester Brush Tooling Gelcoat Green 2606

WGC0015B-1
0 Item
Product available with different options
€25.65
€31.04 Tax incl. €25.65 Tax excl.
Tax excluded

By buying this product you can collect up to 3 point points. Your cart will total 3 points that can be converted into a voucher of €0.30.

Crystic Gelcoat 15PA(B) is designed for use in the manufacture of high quality, FRP composite tooling. It is a pre-accelerated brush gelcoat specially formulated from a vinyl ester base resin and is available in a restricted range of colours. The information contained in this leaflet also applies to pigmented versions.

Choose the type of supply
Color
  • Verde

Ratings and comments from our customers
( 5.0 / 5) - 1 feedback(s)

Crystic Gelcoat 15PA(B) is designed for use in the manufacture of high quality, FRP composite tooling. It is a pre-accelerated brush gelcoat specially formulated from a vinyl ester base resin and is available in a restricted range of colours. The information contained in this leaflet also applies to pigmented versions.

Crystic Gelcoat 15PA(B) is heat resistant with high impact strength and good resistance to chemical attack. It is extremely resilient and can be polished to a high gloss.

Crystic Gelcoat 15PA(B) is a tooling gelcoat and the application should be controlled at 0.4 - 0.6 mm wet film thickness. As a guide, approximately 500 - 750 gm-2 of gelcoat (depending on pigment) will give the required thickness when evenly applied. If left for prolonged periods, Crystic Gelcoat 15PA(B) will cure to an almost tack-free finish, but this has no adverse effect on the adhesion of the backing laminate.

Crystic Gelcoat 15PA requires only the addition of catalyst to start the curing reaction. The recommended catalyst is Butanox M50 (or other equivalent catalyst like Luperox K1S), which should be added at 2% into the gelcoat. (Please consult our Technical Service Department if other catalysts are to be used). 

Gel time: between 7 and 12 minutes at 25 °C with 2% MEKP catalyst (Catalyst X-8: Luperox K1S or Butanox M50) .

Deflection Temperature under load† (1.80 MPa): 106 °C

Type of supply

Crystic 15PA Green Vinylester Brush Tooling Gelcoat x 1 kg, supplied with 20 g of MEKP catalyst

Crystic 15PA Green Vinylester Brush Tooling Gelcoat x 5 kg, supplied with 100 g of MEKP catalyst

Crystic 15PA Green Vinylester Brush Tooling Gelcoat x 25 kg, supplied with 0.5 kg of MEKP catalyst

0 Item
8431252526802

Customers who bought this product also bought:

Ratings and comments from our customers

Score:  
 
Enrique Ma..  -   (Baños de rio Tobia, Spain)
Gran calidad. Facilita mucho el desmoldeo
Product added to wishlist